D-Link DIR-608 User Manual

58D-Link DIR-608 User Manual
Section 3 - Conguration
Wireless Repeater
Wireless Repeater
DIR-608
Wireless
Advanced
Wireless Repeater Setup
These instructions will guide you through setting up your DIR-608 as a wireless repeater in a
few easy steps. Please refer to Wireless Repeater Mode on page 9 for more information.
Step 1: Navigate to the Wireless Repeater section of the web ui, click on the Wireless tab
on the top of the web ui and click Wireless Repeater from the menu on the left hand side
of the screen.
Wireless Repeater Setup
☑
Repeater Enabled(DHCP
mode will be set to ‘none’
if the repeater is enabled)
SSID of AP
Site Survey
# SSID MAC Address Channel Signal Security Select
1 D-Link ff:ff:ff:ff 1 100%
WPA2-
PSK(TKIP)
Click ‘Next’ to Continue repeater settings
Next
Apply
Wireless Repeater Setup
Repeater Enabled: Check the box and click the Apply button in order to enable the
Wireless Repeater function.
SSID of AP: Click the Site Survey button to enable the router to search for nearby
wireless networks. This will take about 5 seconds.
A list of wireless networks that have been found will then appear.
Select the wireless network you wish to extend and click the Next
button.

D-Link DIR-608 Specifications

General

Brand	D-Link
Model	DIR-608
Category	Network Router
Language	English