D-Link DIR-608 User Manual

62D-Link DIR-608 User Manual
Section 3 - Conguration
This page allows you to enable port triggering to specify inbound trac to be sent to specic
ports while other ports are in use for outbound trac.
Port Triggering
Port Triggering Status
This page allows you to set up an Port Trigger Table to restrict the types of data packets that
can enter the network from the Internet.
NAT Port Trigger: Enable or disable the Nat Port Trigger.
Click the Apply Changes button to save any changes made.
Application Type
Usual Application
Name:
Select an application from the dropdown menu.
User-defined
Application Name:
Enter the name of an application.
Start Match Port: Enter a start match port.
End Match Port: Enter a end match port.
Trigger Protocol: Select a protocol from the pulldown menu.
Start Relate Port: Enter a start relate port.
End Relate Port: Enter an end relate port.
Open Protocol: Select a protocol from the dropdown menu.
Port Triggering
Port Triggering
DIR-608
Advanced
Maintenance
Apply Changes
Port Triggering Status
Nat Port Trigger:
Enable Disable
Application Type
Usual Application Name:
Select One
▼
User-dened Application Name:
Start
Match
Port
End Match
Port
Trigger
Protocol
Start
Relate
Port
End
Relate
Port
Open
Protocol
Nat Type
UDP
▼
UDP
▼
outgoing
▼
UDP
▼
UDP
▼
outgoing
▼
UDP
▼
UDP
▼
outgoing
▼
Apply Changes

D-Link DIR-608 Specifications

General

Brand	D-Link
Model	DIR-608
Category	Network Router
Language	English