D-Link DIR-803 User Manual

47D-Link DIR-803 User Manual
Section 3 - Conguration
DHCP Server Settings
DHCP stands for Dynamic Host Control Protocol. The DIR-803 has a built-in DHCP server. The DHCP Server will automatically
assign an IP address to the computers on the LAN/private network. Be sure to set your computers to be DHCP clients by setting
their TCP/IP settings to “Obtain an IP Address Automatically.” When you turn your computers on, they will automatically load
the proper TCP/IP settings provided by the DIR-803. The DHCP Server will automatically allocate an unused IP address from
the IP address pool to the requesting computer. You must specify the starting and ending address of the IP address pool.
Check this box to Enable the DHCP server on your router. Uncheck
to disable this function.
Enter the starting and ending IP Addresses for the DHCP server’s
IP assignment.
Note: If you statically (manually) assign IP addresses to your
computers or devices, make sure the IP addresses are outside of this
range or you may have an IP conict.
The length of time for the IP address lease. Enter the DHCP Lease
Time in minutes.
Enable this feature to broadcast your network’s DHCP server to
LAN/WLAN clients.
NetBIOS allows LAN hosts to discover all other computers within
the network. Enable this feature to allow the DHCP Server to oer NetBIOS conguration settings.
Enable this feature to allow WINS information to be learned from the WAN side. Disable to allow manual conguration.
This is an advanced setting and is normally left blank. This feature allows the conguration of a NetBIOS ‘domain’ name under which
network hosts operate. This setting has no eect if the Learn NetBIOS from WAN option is enabled.
Enable DHCP
Server:
DHCP IP
Address Range:
DHCP Lease
Time:
Always
Broadcast:
NetBIOS
Announcement:
Learn NetBIOS
from WAN:
NetBIOS Scope:

D-Link DIR-803 Specifications

General

Brand	D-Link
Model	DIR-803
Category	Wireless Router
Language	English