67D-Link DIR-803 User Manual
Section 3 - Conguration
If you disable UPnP™ (Universal Plug and Play), you will need to manually open ports or set up application rules for certain
applications. Refer to your application’s documentation or website for port information. Port Forwarding will allow you to open
a single port or a range of ports in your router for specic applications. (Application Rules are covered in the next section.)
Port Forwarding
Enter a Name for the rule or select an Application
Name from the drop-down menu. When an
Application Name is selected, click << to populate
the eld.
Enter the IP Address of the computer on your
local network that you want to allow the incoming
service to. If your computer is receiving an IP address
automatically from the router (DHCP), you computer
will be listed in the Computer Name drop-down
menu. Select your computer and click <<.
Enter the TCP and/or UDP port or ports that you want
to open. You can enter a single port or a range of ports.
Separate ports with a comma.
Example: 24,1009,3000-4000
The schedule of time when the Port Forwarding Rule
will be enabled. The schedule may be set to Always,
which will allow the service to always be enabled.
You can create your own schedule in the Tools >
Schedules section.
Select Allow All (most common) or a pre-dened
Inbound lter. You may create your own inbound
lters in the Advanced > Inbound Filter page.
Name:
IP Address:
Ports to Open
TCP/UDP:
Schedule:
Inbound Filter:
To Next Page
Loading...
Need help?
General
