D-Link DIR-803 User Manual

68D-Link DIR-803 User Manual
Section 3 - Conguration
Enter a Name for the rule. You may select a
pre-dened Application Name from the drop-down
menu and click <<.
Note: The DIR-803 provides some predened applications
that you can select from.
This is the port used to trigger the application. You can
enter either a single port or a range of ports.
This is the port number on the Internet side that will be
used to access the application. You may dene a single
port or a range of ports. You can use a comma to add
multiple ports or port ranges.
Example: 24,1009,3000-4000
Select the protocol of each Trigger and Firewall Port (TCP,
UDP, or Both).
The schedule of time when the Application Rule will be
enabled. The schedule may be set to Always, which will
allow the service to always be enabled. You can create
your own schedule in the Tools > Schedules section.
Name:
Trigger:
Firewall:
Trac Type:
Schedule:
Application Rules
If you disable UPnP™ (Universal Plug and Play), you will need to manually open ports or set up application rules for certain
applications. Refer to your application’s documentation or website for port information. (Opening ports is covered in the
preceding pages, under Virtual Server and Port Forwarding.)
If you need to run applications that require multiple connections, specify the port normally associated with an application
in the Trigger Port eld, select the Trac Type as TCP or UDP, then enter the Firewall (public) Port(s) associated with the
Trigger Port to open them for inbound trac.

D-Link DIR-803 Specifications

General

Brand	D-Link
Model	DIR-803
Category	Wireless Router
Language	English