Name: D-Link DIR-825
Brand: D-Link
Rating: 4 (1 reviews)

To Next Page

To Previous Page

DIR-825  AC1200  Wave  2   MU-MIMO   Wi-Fi   Gigabit   Router
with 3G/LTE Support and USB Port
User Manual
Installation and Connection
Connecting to Web-based Interface
When you have configured your computer, you can access the web-based interface and configure 
needed parameters (create a  WAN  connection,  change  the parameters  of the  wireless  network, 
specify the settings of the firewall, etc.).
!
For security reasons,    DIR-825   with default settings cannot connect to the Internet. To get    
started,  please   set  your  own   password  used   to  access   the  web-based   interface  and,   if 
needed, configure other settings recommended by your ISP.
Start a web browser (see the  Before You Begin  section, page  21).  In the address bar of the web 
browser, enter the domain name of the router (by default, dlinkrouter.local) with a dot at 
the end and press the  Enter  key. Also you can enter the IP address of the device (by default, 
192.168.0.1).
Figure 22. Connecting to the web-based interface of the DIR-825 device.
!
If the error “   The page cannot be displayed   ” (or “   Unable to display the page   ”/“   Could not    
connect to remote server   ”) occurs upon connecting to the web-based interface of the router,    
make sure that you have properly connected the router to your computer.
If the device has not  been  configured  previously  or  the  default settings  have been  restored, after 
access   to   the   web-based   interface  the   Initial   Configuration   Wizard   opens  (see   the  Initial
Configuration Wizard section, page 47).
Figure 23. The page for running the Initial Configuration Wizard.
Page 40 of 249