DIR-853 AC1300 MU-MIMO Wi-Fi Gigabit Router
with 3G/LTE Support and USB Port 3.0
User Manual
Configuring via Web-based Interface
,%
To configure the router's local interface, go to the Connections Setup / LAN page.
IPv4
Go to the IPv4 tab to change IPv4 address, configure the built-in DHCP server, or specify MAC
address and IP address pairs.
Figure 84. Configuring the local interface. The IPv4 tab. The Local IP Address section.
Parameter Description
Local IP Address
Mode of local IP
address assignment
For the Access point, Repeater, and Client modes only.
Select the needed value from the drop-down list.
Static: the IP address, subnet mask, and the gateway IP address are
assigned manually.
Dynamic: the router automatically obtains these parameters from
the LAN DHCP server or from the router to which it connects.
IP address
The IP address of the router in the local subnet. By default, the
following value is specified: 192.168.0.1.
Mask
The mask of the local subnet. By default, the following value is
specified: 255.255.255.0.
Gateway IP address
For the Access point, Repeater, and Client modes only.
The gateway IP address which is used by the router to connect to the
Internet (e.g., for synchronizing the system time with an NTP
server). Optional.
Hostname The name of the device assigned to its IP address in the local subnet.
Page 102 of 228