Section 6 - Connecting a Wireless Client
Connect to a Wireless Client
WPS Button
The easiest way to connect your wireless devices to your Wi-Fi network is with WPS (Wi-Fi Protected Setup). Most wireless devices
such as wireless adapters, media players, Blu-ray DVD players, wireless printers, and cameras will have a WPS button that you can
press to connect to the mesh point. Please refer to your user manual for the wireless device you want to connect to make sure
you understand how to enable WPS. After consulting your device's manual, follow the steps below:
Step 2 - Within 120 seconds, press the WPS button on your wireless device (or launch the software utility and start the WPS
process).
Step 1 - Press the WPS button on the nearest mesh point for about 1 second. The Status LED on the front will start to blink
white.
Step 3 - Allow up to 1 minute for your connection to be congured. Once the LED stops blinking, you will be connected and
your wireless connection will be encrypted with WPA2, the default Wi-Fi security mode.
WPS Button
To Next Page
Loading...
Need help?
General
