D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
179
Chapter 15 Command Logging
Command List
enable command logging
disable command logging
show command logging
15-1 enable command logging
Description
This command is used to enable the command logging function.
NOTE: When the Switch is under the booting procedure or in the procedure of downloading the
configuration, all configuration commands should not be logged. When the user under AAA
authentication, the user name should not changed if user uses “enable admin” command to
replace its privilege.
Format
enable command logging
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.
Example
To enable the command logging function:
DGS-3120-24TC:admin# enable command logging
Command: enable command logging
Success.
DGS-3120-24TC:admin#
15-2 disable command logging
Description
This command is used to disable the command logging function.

D-Link xStack DGS-3120 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3120 Series
Category	Switch
Language	English