D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
933
96-15 config stp version
Description
This command is used to configure the STP version.
Format
config stp version [mstp | rstp | stp]
Parameters
version - To decide to run under which version of STP.
mstp - Multiple Spanning Tree Protocol.
rstp - Rapid Spanning Tree Protocol.
stp - Spanning Tree Protocol.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure STP version:
DGS-3120-24TC:admin# config stp version mstp
Command: config stp version mstp
Success.
DGS-3120-24TC:admin#
To config STP version with the same value of old configuration:
DGS-3120-24TC:admin# config stp version mstp
Command: config stp version mstp
Configure value is the same with current value.
Success.
DGS-3120-24TC:admin#
96-16 show stp instance
Description
This command is used to display each instance parameters settings. Value means the instance ID,
if there is no input of this value, all instance will be shown.
Format
show stp instance {<value 0-15>}

D-Link xStack DGS-3120 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3120 Series
Category	Switch
Language	English