xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
182
Chapter 16
Compound Authentication
Command List
create authentication guest_vlan [vlan <vlan_name 32> | vlanid <vlanid 1-4094>] (RI and EI
Mode Only)
delete authentication guest_vlan [vlan <vlan_name 32> | vlanid <vlanid 1-4094>] (RI and EI
Mode Only)
config authentication guest_vlan [vlan <vlan_name 32> | vlanid <vlanid 1-4094>] [add | delete]
ports [<portlist> | all] (RI and EI Mode Only)
config authentication ports [<portlist> | all] {auth_mode [port_based | host_based {vlanid
<vid_list> state [enable | disable]}] | multi_authen_methods [none | any | dot1x_impb |
impb_jwac | impb_wac | mac_impb| mac_jwac]}(1)
config authentication mac_format {case [lowercase | uppercase] | delimiter {[hyphen | colon |
dot | none] | number [1 | 2 | 5]}(1)}(1)
show authentication guest_vlan (RI and EI Mode Only)
show authentication ports {<portlist>}
enable authorization attributes
disable authorization attributes
config authentication server failover [local | permit | block]
show authentication mac_format
16-1 create authentication guest_vlan (RI and EI Mode Only)
Description
This command is used to assign a static VLAN to be guest VLAN. The specific VLAN which
assigned to guest VLAN must be existed. The specific VLAN which assigned to guest VLAN can’t
be deleted.
Format
create authentication guest_vlan [vlan <vlan_name 32> | vlanid <vlanid 1-4094>]
Parameters
vlan - Specify the guest VLAN by VLAN name.
<vlan_name 32> - Enter the VLAN name here. This name can be up to 32 characters long.
vlanid - Specify the guest VLAN by VLAN ID.
<vlanid 1-4094> - Enter the VLAN ID here. This ID must be between 1 and 4094.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To assign a static VLAN to be guest VLAN:
To Next Page
Loading...
Need help?
General