D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
18
default - Enter this command to return the command prompt to its original factory default value.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To edit the command prompt:
DGS-3120-24TC:admin#config command_prompt Prompt#
Command: config command_prompt Prompt#
Success.
Prompt#:admin#
2-15 config terminal width
Description
The command is used to set current terminal width.
The usage is described as below:
1. Users login and configure the terminal width to 120, this configuration take effect on this
login section. If users implement “save” command, the configuration is saved. After users
log out and log in again, the terminal width is 120.
2. If user did not save the configuration, another user login, the terminal width is default value.
3. If at the same time, two CLI sessions are running, once section configure to 120 width and
save it, the other section will not be effected, unless it log out and then log in.
Format
config terminal width [default | <value 80-200>]
Parameters
default - The default setting of terminal width. The default value is 80.
<value 80-200> - The terminal width which will be configured. The width is between 80 and 200
characters.
Restrictions
None.
Example
To configure the current terminal width:

D-Link xStack DGS-3120 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3120 Series
Category	Switch
Language	English