xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
723
DGS-3120-24TC:admin#show ospf neighbor
Command: show ospf neighbor
IP Address of Router ID of Neighbor Neighbor
Neighbor Neighbor Priority State
--------------- --------------- -------- -------------
10.48.74.122 10.2.2.2 1 Initial
Total Entries : 1
70-24 show ospf virtual_neighbor
Description
This command is used to display the OSPF-neighbor information of OSPF virtual links.
Format
show ospf virtual_
neighbor {<area
_id> <neighbor_id>}
Parameters
<area_id> - (Optional) Specify a 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that
uniquely identifies the OSPF area in the OSPF domain.
<neighbor_id> - (Optional) Specify the OSPF router ID for the remote area. This is a 32-bit
number in the form of an IP address (xxx.xxx.xxx.xxx) that uniquely identifies the remote
area’s Area Border Router.
If no parameter is specified, the system will display all OSPF virtual-link neighbor information.
Restrictions
None.
Example
To display OSPF virtual-link neighbor information:
DGS-3120-24TC:admin#show ospf virtual_neighbor
Command: show ospf virtual_neighbor
Transit Router ID of IP Address of Virtual Neighbor
Area ID Virtual Neighbor Virtual Neighbor State
--------------- ---------------- ---------------- ----------------
10.1.1.1 10.2.3.4 10.48.74.111 Exchange
Total Entries : 1
To Next Page
Loading...
Need help?
General