Dahua 6064 SERIES User Manual

95
Important
 Do not register frequently. The interval between two registrations shall be more than 60 seconds. Too
many registration requests may result in server attack.
 System may take back the domain name that is idle for one year. You can get a notification email
before the cancel operation if your email address setup is OK.
3.11.1.4 UPnP
The UPNP protocol is to establish a mapping relationship between the LAN and the WAN. Please input
the router IP address in the LAN in Figure 3-93. See Figure 3-97.
 UPNP on/off ：Turn on or off the UPNP function of the device.
 Status: When the UPNP is offline, it shows as “Unknown”. When the UPNP works it shows
“Success”
 Router LAN IP: It is the router IP in the LAN.
 WAN IP: It is the router IP in the WAN.
 Port Mapping list： The port mapping list here is the one to one relationship with the router’s port
mapping setting.
 List：
 Service name：Defined by user.
 Protocol： Protocol type
 Internal port：Port that has been mapped in the router.
 External port：Port that has been mapped locally.
 Default: UPNP default port setting is the HTTP, TCP and UDP of the NVR.
 Add to the list: Click it to add the mapping relationship.
 Delete: Click it to remove one mapping item.
Double click one item; you can change the corresponding mapping information. See Figure 3-98.
Important:
When you are setting the router external port, please use 1024~5000 port. Do not use well-known
port 1~255 and the system port 256~1023 to avoid conflict.
For the TCP and UDP, please make sure the internal port and external port are the same to
guarantee the proper data transmission.

Dahua 6064 SERIES Specifications

General

Brand	Dahua
Model	6064 SERIES
Category	Network Hardware
Language	English