6 | Operation
User reference guide
42
CVXM-A, FVXM-A, CVXM-A9, FVXM-A9, FVXTM-A
Split system air conditioners
4P625990-1D – 2022.09
6.14.1 Priority room setting
Priority room setting requires initial programming during installation. Please
consult your authorized dealer for assistance.
When priority room setting is inactive or not present
When more than 1 indoor unit is operating, priority is given to the first unit that
was turned on. Set other units to the same operation mode. Otherwise, they will
enter the standby mode, and the Daikin eye will flash (does NOT indicate
malfunction).
Exceptions: If the first unit that was turned on is set to fan only, and then in the
other room heating mode is set, priority will be given to the unit set to the heating
mode. The first unit will go in standby and the Daikin eye will flash.
INFORMATION
▪ The cooling, drying, and fan only operation modes may be used at the same time.
▪ The automatic operation mode automatically selects cooling or heating,
depending on the room temperature and the temperature setting. If the
automatic operation mode is selected for all units, all units will operate in the
mode of the first unit that was turned on.
Priority when using Outdoor unit quiet operation
Refer to "6.9.2Outdoor unit quiet operation"[430].
1 Set Outdoor unit quiet operation in all rooms using the wireless remote
controls of the units.
2 To cancel Outdoor unit quiet operation, you may stop operation in 1 room
using a wireless remote control.
Result: Operation will stop in all rooms. will remain on the display of the
other wireless remote controls.
3 To remove the symbol from the other wireless remote controls, stop Outdoor
unit quiet operation in all rooms separately.
Result: The symbol will disappear.
When priority room setting is active
You can select a different operation mode for each room.
Example: Room A has priority, cooling operation mode is selected.
Operation mode in room B andC Status of room B and C
Cooling, drying or fan only Current operation mode maintained
Heating Standby mode. Operation resumes when
room A stops operating.