Mounting
EI.65.D4.02
5
3. MOUNTING
The ECL 2000 can be mounted in three different ways: on wall, in panel, and on
DIN rail.
The controller comes with a Quick Guide which must be attached to the inside of
controller’s door (see Figure 6 on page 6).
3.1 Wall Mounting
For mounting on wall, you use a base plate with associated case (code no.
087B8099).
Note:
When deciding where to place the controller, remember that you must leave suffi-
cient space for cable installation.
1. Place the base plate on the wall and accurately mark the positions of the
three fixing holes. Remember that the arrow on the inside of the base
plate must point upwards (see Figure 4).
Figure 4. ECL 2000 base plate with fixing hole positions and terminal blocks fitted
2. When all three holes are drilled, the base plate can be fixed with the
three ø3 screws.
3. Fit the terminal blocks to the back plate and connect wires (for informa-
tion on electrical connections, see page 11).
4. Mount the case.
5. Position the controller in the case as shown in Figure 5.
To Next Page
Loading...
Need help?
General
