Danfoss VLT AutomationDrive FC 300 Series Design Guide

FC 300 Design Guide
How to Install
" Motor connection
NOTE
Motor cable must be shielded/arm ored. If
an unshielded/unarmored cable is used,
some EMC requirements are not complied
with. For more information, see EMC specifications.
1. Fasten grounding plate to the bottom of FC 300
with scre ws and washers from the accessory bag.
2. Attach motor cable to terminals 96 ( U),
97 (V ), 98 (W).
3. Connect to ground connection (terminal
99) on decoupling plate with screws from
the accessory bag.
4. Insertterminals96(U),97(V),98(W)and
motor cable to terminals labelled MOTOR.
5. Fasten shielded cable to grounding plate with
screws and washers from t he acces sory bag.
88
MG.33.B3.22 - VLT is a registered Danfoss trademark

Danfoss VLT AutomationDrive FC 300 Series Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 300 Series
Category	DC Drives
Language	English