Danfoss VLT AutomationDrive FC 300 Design Guide

1 How to Read this Design Guide
1.1 How to Read This Design Guide - FC 300
This contains information proprietary to Danfoss. By
accepting and using this manual, the reader agrees that
the information contained herein will be used solely for
operating units from Danfoss or equipment from other
vendors provided that such equipment is intended for
communication with Danfoss units over a serial communi-
cation link. This publication is protected under the
copyright laws of Denmark and most other countries.
Danfoss does not warrant that a software program
produced according to the guidelines provided in this
manual functions properly in every physical, hardware, or
software environment.
Although Danfoss has tested and reviewed the documen-
tation within this manual, Danfoss makes no warranty or
representation, neither expressed nor implied, with respect
to this documentation, including its quality, performance,
or fitness for a particular purpose.
In no event shall Danfoss be liable for direct, indirect,
special, incidental, or consequential damages arising out of
the use, or the inability to use information contained in
this manual, even if advised of the possibility of such
damages. In particular, Danfoss is not responsible for any
costs, including but not limited to those incurred as a
result of lost profits or revenue, loss or damage of
equipment, loss of computer programs, loss of data, the
costs to substitute these, or any claims by third parties.
Danfoss reserves the right to revise this publication at any
time and to change its contents without prior notice or
any obligation to notify former or present users of such
revisions or changes.
FC 300
Design Guide
Software version: 6.6x
This Design Guide can be used for all FC 300 adjustable
frequency drives with software version 6.6x.
The software version number can be seen from 15-43 Software
Version.
Table 1.1 Software Version Label
1.2
Available Literature
1.2.1
Available Literature for VLT
®
AutomationDrive
•
The Instruction Manual is shipped with the unit
and includes information on installation and
startup.
•
The Design Guide includes all technical
information about the adjustable frequency drive,
frames D, E, and F, and customer design and
applications.
•
The Programming Guide provides information on
how to program and includes complete
parameter descriptions.
•
The Profibus Instruction Manual provides
information on how to control, monitor, and
program the adjustable frequency drive via a
Profibus serial communication bus.
•
The DeviceNet Instruction Manual provides
information on how to control, monitor, and
program the adjustable frequency drive via a
DeviceNet serial communication bus.
Danfoss technical literature is available in print from local
Danfoss sales offices or online at: www.danfoss.com/
BusinessAreas/DrivesSolutions/Documentations/Technical
+Documentation.htm
How to Read this Design Gui... Design Guide
MG34S222 Danfoss A/S © Rev. 2014-02-10 All rights reserved. 9
1
1

Danfoss VLT AutomationDrive FC 300 Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 300
Category	DC Drives
Language	English