DataCard LM200 Installation Guide

14 Installing the Hardware Components
3. IfyoursystemincludesanLM200orLM300laminator,plugtheprovidedpowercordintothe
backofthelaminator.
4. Plugthepowercord(s)intothefacilitypowersource.
5. Ifthisisthefirsttimeyouareusingtheprinter,powerontheprinterandlaminatorwithout
installingsupplies.Keepthepoweronforabout 30seconds,untilaninkerrororafilmerror
occurs,thenpoweroff.
(Theprinter
andoptionallaminatorareshippedintransportmode.Inkribbonandretransfer
material,andlaminatormaterialcannotbeinstalledintransportmode.Poweroncancels
transportmodeandallowssuppliestobeinstalled.)
Connecting the Data Cable
ConnecttheUSBornetworkdatacableonlywhentheprinterdriverinstallationinstructionstell
youtodosoinChapter4orChapter6.
Iftheprinterhasbeenusedpreviously,thetypeofconnectiondisplaysontheprinterLCDpanel
whentheprinterispoweredon:
 TheUSBsymbolis:
 Thenetwork(LAN)symbolis:
ThedefaulttypeofconnectionisNetwork.Tosetotherconnectionvalues,referto“Settingthe
UnitNumber,PrinterName,andConnection”onpage 59.
For best results, connect only one data cable to the printer and PC before powering on the
printer.

DataCard LM200 Specifications

General

Brand	DataCard
Model	LM200
Category	Laminator
Language	English