DataCard LM200 Installation Guide

20 Installing the Smart Card Driver
Installing the Identive Dual Contact/Contactless
Driver
TheIdentiveDualContact/Contactlesssmartcarddriverinstallationstartsautomaticallywhen
theSR200orSR300cardprinterisconnectedtoyourPC.Youneedtouseawebsitetoinstallthe
driveronlyiftheinstallationdoesn'tstartupautomatically.(Referto“DownloadingandInstalling
theIdentiveDriverManually”on
page 21.)
Installing the Identive Driver Automatically
1. ConnecttheprinterUSBcabletothecomputerandpo werontheprinter.
Thecomputerinstallsthedevicedriversoftwareforthesmartcard.
“Yourdeviceisreadytouse”displaysafterthedriverinstallationiscomplete.
2. AftertheIdentivesmartcardreaderhasbeeninstalled,verifythatthedriverdisplaysin
DeviceManagerunderSmartcardreaders.
3. VerifythattheIdentivesmartcardalsodisplayinDevicesandPrinters.

DataCard LM200 Specifications

General

Brand	DataCard
Model	LM200
Category	Laminator
Language	English