To Next Page

To Previous Page

CONFIGURATION WITH BAR CODES

QUICKSCAN™ 2500

Symbology-specific parameters:

1D Symbologies, starting on page 111 and 2D Symbologies, starting on page 196 define

options for all symbologies and provides the programming bar codes necessary for con-

figuring these features.

To program features:

1. Scan the ENTER/EXIT PROGRAMMING bar code, available at the top of each pro-

gramming page, when applicable.

2. Scan the bar code to set the desired programming feature. You may need to cover

unused bar codes on the page, and possibly the facing page, to ensure that the

reader reads only the bar code you intend to scan.

3. If additional input parameters are needed, go to

Appendix D, and scan the appro-

priate characters from the keypad.

4. Complete the programming sequence by scanning the ENTER/EXIT PROGRAM-

MING bar code to exit Programming Mode.

For more detailed descriptions, programming information and examples for setting

selected configuration items, see

References, starting on page 260.

NOTE: You must first enable your reader to read bar codes in order to use

this section. If you have not done this, go to

Setup, starting on page 9 and

complete the appropriate procedure.

NOTE: Additional information about many features can be found in the

References, starting on page 260.

If you make a mistake before the last character, scan the CANCEL bar code

to abort and not save the entry string. You can then start again at the

beginning.

Datalogic QuickScan QBT2500 User Manual

Other manuals for Datalogic QuickScan QBT2500