MAXICODE ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
203
Maxicode Length Control
This feature specifies either variable length decoding or fixed length decoding for this
symbology.
Variable Length:
For variable length decoding, a minimum and maximum length may
be set.
Fixed Length:
For fixed length decoding, two different lengths may be set.
Maxicode Set Length 1
Specifies one of the bar code lengths for "Maxicode Length Control" on page 203. Length
1 is the minimum label length if in Variable Length Mode, or the first fixed length if in
Fixed Length Mode. Characters can be set from 0001 to 0145 characters in increments
of 0001 (pad with zeroes).
See "
Set Length 1" on page 249 for detailed instructions on setting this feature.
$CMXLC00
Maxicode Length Control = Variable Length
Maxicode Length Control = Fixed Length
$CMXLC01
Select Maxicode Length 1 Setting
$CMXL1
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in Appendix D, Keypad represent-
ing your desired character(s). End by scanning the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
0001 = Length 1 is 1 Character
To Next Page
Loading...
Need help?
General
Weight and Dimensions
