RS-232/USB-COM SETTINGS ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
31
ACK NAK Timeout Value
This option specifies the amount of time the reader waits for an ACK character from the
host following label transmission. The selectable timeout range is 200 milliseconds to
15,000ms (15 seconds) in 200ms increments. A selection of 0 disables the timeout. See
"
ACK NAK Timeout Value" on page 228 for more detailed programming instructions.
ACK NAK Retry Count
This feature specifies the number of times the reader retries a label transmission due to
a retry condition. The selectable range is from 1 to 254 retries. A selection of 0 disables
the count, and a selection of 255 specifies unlimited retries. See "
ACK NAK Retry Count"
on page 229 for more detailed programming instructions.
Select ACK NAK Timeout Value Setting
$CR2AT
To configure this feature, scan the ENTER/EXIT bar
code above, then the bar code at left followed by dig-
its from the Alphanumeric characters in Appendix D
representing your desired character(s). End by scan-
ning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
01 ACK NAK Timeout value is 200ms
Select ACK NAK Retry Count Setting
$CR2AR
To configure this feature, scan the ENTER/EXIT bar
code above, then the bar code at left followed by dig-
its from the Alphanumeric characters in Appendix D
representing your desired character(s). End by scan-
ning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
003 = 3 Retries
To Next Page
Loading...
Need help?
General
Weight and Dimensions
