Back to Contents Page
Speakers
Dell™Inspiron™1090ServiceManual
Removing the Speakers
Replacing the Speakers
Removing the Speakers
1. Follow the instructions in Before You Begin.
2. Remove the system board (see Removing the System Board).
3. Remove the two (one on each speaker) screws that secure the speakers to the computer base.
4. Lift the speakers along with their cable off the computer base.
Replacing the Speakers
1. Follow the instructions in Before You Begin.
2. Place the speakers on the computer base and route the speaker cable through the routing guides.
3. Replace the two screws that secure the speakers to the computer base.
4. Replace the system board (see Replacing the System Board).
Back to Contents Page
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside the
computer.
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
To Next Page
Loading...
Need help?
General
