EasyManuals Logo
Home>Denon>Car Receiver>RCD-M38

Denon RCD-M38 Service Manual

Denon RCD-M38
95 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
24
6. Accumulated laser on time display mode
(1) Plug AC cord into power outlet while pressing ON/STANDBY and
2
button same time on Main Unit.
X X X X X h o u r
L A S E R O N T I M E
• Thelaserdrivetimesareaddedandtheresultisdisplayed.
• Onecountcorrespondsto10minutes.(Valuesunder10minutesarediscarded.)
• CountvaluesarestoredintheEEPROMevery10minutes.
• Theaccumulatedlaserontimeisdisplayedinhours.
• Thecountvaluesarenotcleared,evenwhenthesetisinitialazation(3.Coldstartmode).
• Minimumdisplayspecication.
•No.digitsstoredinEPROM:4,0xFFFF
•No.digitsdisplayed:5
•Whenthetimeexceeds10922hours,thestoreddataisnotupdatedandthevalueisxedto0xFFFF.
(Thedisplayisxedto10922hours.)
(2) Unplug AC cord to clear this mode.
6.1 Count value is reset
(1) When the
1
/
3
button is pressed for over 5 seconds while the acumulated laser on time is displayed, the count value
is reset.
C L E A R
L A S E R O N T I M E
(2) After resetting is completed, the display in "6. Accumulated laser on time display mode(1)" (00000 hours on the top
line) reappears.
Count value is reset upon shipment from the factory and when the mechanism is replaced.
7. Displaying the protection history mode
(1) Plug AC cord into power outlet while pressing SDB/TONE and +/
9
button same time on Main Unit.
(2) The last protection incident.
(3) Unplug AC cord to clear this mode too.
No protection incident
P R O T E C T I O N :
N O P R O T E C T
The last protection incident was AMP protection
P R O T E C T I O N :
A M P
The last protection incident was Power protection
P R O T E C T I O N :
P O W E R
7.1 Clearing the protection history
(1) Start up the error (protection history display) mode, display the error, then press and hold in the
1
/
3
button over 5
seconds.
Display of Clearing
P R O T E C T I O N :
C L E A R
Protection history reset by initialazation (3. Cold start mode), too.

Other manuals for Denon RCD-M38

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon RCD-M38 and is the answer not in the manual?

Denon RCD-M38 Specifications

General IconGeneral
BrandDenon
ModelRCD-M38
CategoryCar Receiver
LanguageEnglish

Related product manuals