To Next Page

To Previous Page

ENGLISH

Rechargeable Battery Pack

This long life battery pack must be recharged when it fails to produce

sufficient power on jobs which were easily done before. At the end

of its technical life, discard it with due care for ourenvironment:

Guard Types for DCG409VS, DCG416VS

Type B

(Shallow, Grinding)

Type A

(Closed cut off)

Type E

(Diamond surface grinding wheel

guard))



Type A (Type 41) guards are intended for use with Type 41(1A) cutting wheels and Type 42(27A)wheels marked for cutting only.

Grinding with wheels other than Type 27and Type 29require different accessory guards. Always use the smallest proper guard

possible that does not contact theaccessory.

NOTE: Type A (cut-off) and Type B (grinding) wheel guards where previously referred to as Type 1/41and Type 27wheelguards.

Additional Information for Guards and Accessories for DCG409VS, DCG416VS

When using segmented diamond wheels, use only

diamond wheels with a peripheral gap not greater than

10mm and negative rakeangle.

≤10 mm

DO NOT USE

segmented diamond wheels with a peripheral gap greater

than 10mm and/or a a positive rakeangle.

For all grinding, sanding, and wheel type wire brushing

accessories, the lowest portion of the accessory must

be contained within the guard enclosure with 2mm or

greater clearance to the bottom lip of guard

≥2 mm

• Run the battery pack down completely, then remove it from

thetool.

• Li-Ion cells are recyclable. Take them to your dealer or a

local recycling station. The collected battery packs will be

recycled or disposed ofproperly.

DeWalt XR DCG409VS Original Instructions

Other manuals for DeWalt XR DCG409VS