Digi AnywhereUSB 8 Plus User Manual

Configure the AnywhereUSB Manager from the command line known hub add
AnywhereUSB® Plus User Guide
106
known hub add
Purpose
Add a Hub to the known Hubs list. The Hubs in this list can be on the same network as your computer,
or on a different network. If you add Hubs to the known Hubs list that are on the same network as our
computer ANDthe autofind feature is enabled, duplicate entries display in the Hubs list.
Note For information about using this feature in the AnywhereUSBManager, see Manage the list of
known Hubs.
Syntax
>awusbmanager known hub add,< address> [: port ]
The <address> is the address of the Hub or a Hub hostname that can be resolved by your network
nameservers. This is required.
The <port> is the TCPport number, which is 18574 by default. You can change the TCP port number if
needed.
Examples
Add a known Hub
Run the known hub add command to add a Hub to the known Hub list.
n Use and address and the default port of 18574:
>awusbmanager known hub add,10.10.56.12
n Use a hostname and change the TCPport number:
>awusbmanager known hub add,awusb1.work.com:9999
n Change the TCPport number:
>awusbmanager known hub add,10.10.56.14:5600
You can then run the known hub list command to verify that the Hub was added to the list.
10.10.10.56:18574
awusb1.work.com:9999
10.10.56.14:5600

Digi AnywhereUSB 8 Plus Specifications

General

Brand	Digi
Model	AnywhereUSB 8 Plus
Category	Switch
Language	English