Configure the device using the ConnectPort LTS web interface Configuration through the web interface
Digi ConnectPort LTS User Guide
75
n Post-delay: The number of milliseconds to wait after sending data before turning off the RTS
signal. This can be 0 to 5000 milliseconds but is usually set to 0. This setting only appears when
you are configuring a Console Management, Modem, or RealPort profile.
n Enable DCD on 8-pin RJ45 connectors (Altpin): When enabled, the functions of DCD pin and
DSR pin are swapped so that you can use eight-wire RJ-45 cables with modems. This setting
only appears when you are configuring a Console Management, Modem, RealPort, and or
Sockets profile.
TCP Settings
These TCP Settings are available only when you configure the current port with the Console
Management, Custom, or TCP Sockets profile.
n Send Socket ID: Include an optional identifier string with the data sent over the network.
The Socket ID can be 1 to 256 ASCII characters. Enter non-printable characters as
follows:
Character
Key
Sequence
backspace \b
formfeed \f
tab
\t
line feed
\n
return \r
backslash
\\
hexadecimal
values
\xhh
n Send data only under any of the following conditions: Enable if you need to specify the
conditions when the Digi device server will send the data read from the serial port to the TCP
destination.
To Next Page
Loading...
Need help?
General