DVM-750 Installation Guide 860-0008-00 Rev C
Digital Ally, Inc |DVM-750 Installation Guide
SYSTEM INSTALLATION
The current factory rearview mirror must be removed from the windshield mounting plate. There
are several versions of mirror mounting systems. Below are the most common methods of
rearview mirror removal. Do not use excessive force when removing the mirror from the
windshield. The mirror mounting plate may become separated from the windshield and/or the
windshield may break if excessive force is used.
Use one of the following methods below that matches the mirror mounting configuration of your
vehicle:
1. Using a Philips screwdriver or #20 Torx bit, loosen the screw in the base of the mirror.
2. After loosening the screw, gently lift upward to slide mirror off of mirror mount.
2011-2012 Dodge Charger Rearview Mirror Removal
1. With your right hand, grip the mirror and keep it stabilized.
2. With your left hand, grip the base of the factory mount where it meets the glass.
3. Gently apply a small amount of additional inward force toward the glass and rotate the
base clockwise.
4. The spring loaded factory mount should release from the windshield4 puck. See picture
below.
1. Remove front passenger side threshold.
Step 1: Factory Mirror Removal
Step 2: Remove Factory Body Trim
To Next Page
Loading...
Need help?
General
