3590EKR, 3590EXP, 3590EXT, CPWE, CPWET series indicator E-AF09_02_16.03_EN_U
The operation can be made either with a loaded or unloaded platform.
NOTE
- In the printout, the manual tare is identified with “PT” (Preset Tare).
7.2 CALCULATED MANUAL TARE
With the "CALCULATOR" function one can add or subtract from the current tare the result of an operation between two
values entered with the keyboard.
For the functioning specifics see the 15.3 CALCULATOR section.
7.3 TARE CANCELLATION
To cancel the stored tare:
- Deselect the active vehicle.
- With an unloaded platform, press the TARE key.
- With loaded platform press in sequence the numeric 0 key and TARE.
- Press the C key.
NOTE: the selection of vehicle linked to a tare equal to 0 has no effect on the present tare.
7.4 LOCKED/UNLOCKED TARE
Normally, when a tare value has been entered (automatically, manually or from storage), if one unloads the scale plate, the
tare value remains active (LOCKED TARE). One can also choose that the tare value is cancelled automatically each time
that the scale is unloaded (LOCKED TARE):
In case of SEMIAUTOMATIC TARE, the net weight before the scale unloading may also be 0.
In case of MANUAL TARE, the net weight before the scale unloading must be of at least 2 stable divisions.
If the F5 key is pressed at length, it is possible to quickly lock/unlock the tare:
DISPLAY MEANING
LoCK LOCKED TARE
unLoCK UNLOCKED TARE
The setting of the tare may be made also in the "TARE LOCK/UNLOCK" SEtuP >> tare t parameter of the TECHNICAL
SETUP, TECH.MAN.REF.
7.5 LIMITATION OF THE TARE FUNCTIONS
For specific requirements, it is possible to limit the tare functions with approved instrument; by setting “YES” in the SEtuP
>> d.SALE step of the SET-UP environment (TECH.MAN.REF.):
- the SEMIAUTOMATIC TARE can not be modified with a manual or calculated tare.
- the manual or calculated tare must be entered or modified only with an UNLOADED scale.
With approved instrument, the SEtuP >> d.SALE step is read-only.
7.6 TARE EXECUTION MODE OR DISABLING OF THE TARE
It’s possible to select the tare execution mode, through the setting of the F.ModE >> totAL >> tArE t step
(TECH.MAN.REF.):
- By setting "diSAbL" one disables all the tare operations;
- By setting "Lock" or “Unlock”, all the tare operations described in section 7.4 are enabled.
7.7 ENTERING OF A PRESET TARE IN A VEHICLE IN THE DATABASE.
It is possible to enter a known tare value in each vehicle in the database; this value will be enabled with each selection of the
vehicle.
See section 11.3 for further details.
To Next Page
Loading...
Need help?
General
