- 157 -
LP Engine G430(3.0L) Base Engine Service Procedure
6. Inspect the pump for smoothness of operation by
turning the oil pump driveshaft by hand.
7. Install the oil pump screen.
(1) If removed, replace the oil pump screen. The oil
pump screen must have a good press fit into the
oil pump body.
(2) Mount the oil pump in a soft jawed vise.
(3) Apply sealer to the end of the pipe.
(4) Use the J 21882 and a soft-faced hammer in
order to tap the oil pump screen into the pump
body. The screen must align parallel with the
bottom of the oil pan when it is installed.
Cylinder Head Disassemble
Tools Required
• J 8062 Valve Spring Compressor
IMPORTANT: Mark, organize or sort the cylinder head
components for assembly. Return the components to
their original location during assembly.
1. Measure the valve spring installed height using a
ruler.
Measure from the machined surface of the cylinder
head to the top of the valve spring cap. Refer to
Engine Mechanical Specifications.
2. Use the J 8062 in order to compress the valve
springs
VE089-3L
VE088-3L
VE087-3L
To Next Page
Loading...
Need help?
General
