- 169 -
LP Engine G430(3.0L) Base Engine Service Procedure
2. Install the engine front cover gasket.
3. Install the engine front cover and bolts.
Tighten
Tighten engine front cover bolts to 3.4 N•m (30 lb•in).
Oil Pump Installation
IMPORTANT: Inspect the oil pump and engine block
oil galley passages. These surfaces must be clear and
free of debris or restrictions.
1. Install the oil pump.
2. Install the bolts that attach the oil pump to the
engine block.
Tighten
Tighten the oil pump bolts to 14 N•m (120 lb•in).
Oil Pan Installation
IMPORTANT: Apply the sealer 25 mm (1.0 in) in either
direction of the radius cavity of the junctions.
1. Apply a small amount of sealer, GM P/N 1052914 or
equivalent, 10 mm (0.393 in) wide and 20 mm
(0.787 in) long at the engine front cover to engine
block junction.
2. Apply a small amount of sealer, GM P/N 1052914 or
equivalent, 25 mm (1.0 in) long at the crankshaft
rear oil seal housing to engine block junction.
3. Install the new oil pan gasket.
4. Install the oil pan.
5. Install the nuts and bolts to the oil pan.
Tighten
Tighten the rear oil pan nuts to 18.6 N•m (165 lb•in).
Tighten the oil pan bolts to the crankcase to 9 N•m (80
lb•in).
Tighten the oil pan bolts to the front cover to 5 N•m (45
lb•in).
Tighten the oil pan studs to the oil seal retainer to 1.7
N•m (15 lb•in).
VE111-3L
VE110-3L
VE030-3L
To Next Page
Loading...
Need help?
General
