1
Safety precautions
OPERATIONAL MANUAL MN156001EN October 2015 www.eaton.com
Safety precautions
Installation, wiring, testing and service must be performed
in accordance with all local and national electrical codes.
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR
ARC FLASH
• Apply appropriate personal protective equipment
(PPE) and follow safe electrical work practices. See
NFPA 70E in the USA, CSA Z462, or applicable local
standards
• This equipment must be installed and serviced only
by qualified electrical personnel
• Do not exceed the device’s ratings for maximum
limits.
• Ground equipment using the ground connecting
point provided before turning on any power supplying
this device
• Turn off all power supplying this device and the
equipment in which it is installed before working
on the device or equipment
• After removing power, wait for 15 minutes to allow
the capacitors to discharge prior to opening the doors
or removing covers
• Always use a properly rated voltage sensing device to
confirm power is off
• Replace all devices, doors, and covers before turning
on power to this equipment
• Carefully inspect the interior for tools left behind
before closing and sealing the door
Failure to follow these instructions will result in death
or serious injury.
To Next Page
Loading...
Need help?
General
