8
Reference Manual
00809-0100-4108, Rev BA
Section 2: Configuration
March 2014
Configuration
2.3 System readiness
If using HART based control or asset management systems, confirm the HART
capability of such systems prior to commissioning and installation. Not all systems are
capable of communicating with HART revision 7 devices.
For instructions on how to change the HART revision of your transmitter, see
“Switching HART revision” on page 61.
2.3.1 Confirm correct device driver
Verify the latest Device Driver (DD/DTM) is loaded on your systems to ensure proper communi-
cations.
1. Download the latest DD at www.emersonprocess.com or www.hartcomm.org.
2. In the Browse by Member dropdown menu, select Rosemount business unit of Emerson
Process Management.
3. Select desired Product
a. Within Ta bl e 2 -1 , use the HART Universal Revision and Device Revision numbers to find
the correct Device Driver
Explosions could result in death or serious injury.
Installation of this transmitter in an explosive environment must be in accordance with the
appropriate local, national, and international standards, codes, and practices. Please review
the approvals section of the Rosemount 2088 reference manual for any restrictions
associated with a safe installation.
Before connecting a field communicator in an explosive atmosphere, ensure the
instruments in the loop are installed in accordance with intrinsically safe or
non-incendive field wiring practices.
In an explosion-proof/flameproof installation, do not remove the transmitter covers
when power is applied to the unit.
Process leaks may cause harm or result in death.
Install and tighten process connectors before applying pressure.
Electrical shock can result in death or serious injury.
Avoid contact with the leads and terminals. High voltage that may be present on leads
can cause electrical shock.
To Next Page
Loading...
Need help?
General
