k. Connect one end of a second Ethernet cable to the second bridge, and connect the other end of
the Ethernet cable into the broadband router.
Within two minutes the Network Communications LED lights solid green, indicating a successful
connection to the Internet and to Enlighten.
If the Internet Connection Fails
After using any of these connection methods, if the Envoy-S does not connect to the Internet within five
to ten minutes after you attempt a connection, see “Internet Connection Issues” on page 36.
10. Send System Summary Report
When you have completed your system setup, you can generate and email a summary report.
a. From Installer Toolkit, tap Done in the upper-right corner of the screen to disconnect from the
Envoy. Installer Toolkit will ask if you want to view a summary report.
b. Tap View Report. The report displays Envoy and system information with a list of device serial
numbers, their last power reports, and information about the grid profile applied to the devices.
c. Tap to email the report as needed as a record of successful system installation and for
evidence of grid profile settings.
NOTE: If your mobile device is connected to the Envoy using AP mode, the email stays in the
email outbox to be sent when the mobile device reconnects to the Internet. To disconnect
from the Envoy network, go to Settings on your mobile device and disconnect from the
Envoy-S Wi-Fi network “Envoy_nnnnnn” (where “nnnnnn” represents the final six digits of the
Envoy serial number).
NOTE: If you connect to an Envoy after associating it to a system, the report includes a
system name and address. For more information, refer to the Enphase Installer Toolkit
Operation Manual at: enphase.com/support.
To Next Page
Loading...
Need help?
General