Sigma DS1, DS2, DS3 Card Printer User’s Guide 73
149: Option not installed
The printer does not support the personalization being requested for the card. The card will be
canceled.
Change the card data to match the printer’s options and settings, or print to a printer that is
configured to support the personalization being requested.
Press the User button on the printer to clear the message. Or, click OK in the Card Printer Driver
message.
HINTS & TIPS
In the card format, don’t include references to hardware that cannot be accessed by the system.
For more information, refer to your ID software documentation or ask your system administrator.
150: Print while unlocked
The printer is unlocked. The card will be canceled.
Make sure that all access doors are closed securely and locked.
Click OK in the Card Printer Driver message.
151: Failed to lock
An attempt to lock the printer failed. The card will be canceled.
1. Make sure that all access doors are closed securely.
2. Try locking the printer again.
Click OK in the Card Printer Driver message.
HINTS & TIPS
Make sure that the reject tray is installed properly before locking the printer.
152: Insert new card side 2 up
1. Turn a new card over end to end so side 2 is facing up.
2. Insert the card in the printer.
3. If the card is not immediately picked, press the printer’s U
SER button or click OK.
Click Cancel in the Card Printer Driver message to cancel the card.
To Next Page
Loading...
Need help?
General
