Sigma DS1, DS2, DS3 Card Printer User’s Guide 77
502: The card data is missing or is not usable
The printer driver has detected invalid or missing data. The card will be canceled.
Make sure the data being sent is formatted properly and matches the options and settings in the
printer.
Click OK to clear the message.
504: The card data is missing or is not usable
The printer driver has detected invalid or missing data. The card will be canceled.
Make sure the data being sent is formatted properly and matches the options and settings in the
printer.
Click OK to clear the message.
505: USB communication issue
An important driver component is not running. The card will be canceled.
1. Restart the computer. The component should start automatically.
2. If this message is displayed after restarting, notify your printer support contact.
Click OK to clear the message.
506: A card is currently processing
The printer is busy processing an interactive job. The card will be canceled.
Wait until the current card is complete and then try again.
Click OK to clear the message.
507: The printer is unlocked
The printer must be locked to print.
To complete the current card make sure that all access doors are closed securely and locked.
Click OK to clear the message, or click Cancel to cancel the card.
508: The printer is shutting down
The printer is shutting down or resetting. The card will be canceled.
When printer is powered back on, try again.
Click OK to clear the message.
To Next Page
Loading...
Need help?
General
