L (Load and remove media)
Press when loading or removing media.
U “Loading Media” on page 36
U “Removing Media” on page 43
Home screen (adjust while printing)
The following section only describes parts that differ from the Home screen (status display). You can change the
value for each adjustment item even while printing. Results of the adjustments are registered to the currently
selected Media Settings.
A Adjust Drying Time per Pass
Displays the Drying Time per Pass setting for the selected Pass Mode for the currently selected registered me‐
dia number. Press the following to change the value.
:To reduce the display time
:To increase the display time
B Media Feed Adjustment
To correct banding that occurs during printing, press this area to perform media feed corrections.
If the feed amount is too small, black bands (dark stripes) appear; correct the feed amount upwards (+).
In contrast, if the feed amount is too large, white bands (pale stripes) appear; correct the feed amount down‐
wards (-). The value indicates the amount of feed that has been corrected as a percentage or as a positive (+) or
negative (-) value.
SC-F6400 Series/SC-F6400H Series User's Guide
Introduction
21
To Next Page
Loading...
Need help?
General