C Adjust Paper Suction
Set the strength of the suction by the platen on the media. The higher the value, the greater the suction.
In most situations, use the values set for each media type as they are. If the media is wavy on the platen, in‐
crease the set value.
If graininess or out-of-focus characteristics are detected in printing results obtained using thin or soft media or
if the media is not fed normally, reduce the set value.
Pressing
/ allows you to change the values.
D Adjust Feeding Tension
Increase tension if creases appear in the media during printing. The higher the value, the greater the tension.
Pressing
/ allows you to change the values.
Operating procedure
The black background area on the home screen does not respond even if you press it. When you press the gray
tiled area in the operation area, the screen or the value changes.
Depending on the printer’s operating status, you may not be able to perform the function for every button
displayed at the top of the screen. If the function is unavailable, the icon is grayed out and the button does not
respond.
Operation areas do operations when pressed. However, when a scroll bar is displayed as shown below, you can
scroll the screen by moving (sliding) your finger up and down on the screen. You can also scroll by pressing on the
up and down icons on the scroll bar.
SC-F6400 Series/SC-F6400H Series User's Guide
Introduction
22
To Next Page
Loading...
Need help?
General