EPSON Stylus C110/C120/D120 Revision B
TROUBLESHOOTING Troubleshooting 45
3.2.2 Error Indications and Fault Occurrence Causes
This section describes the LED indications, STM3 messages and fault occurrence causes at occurrence of the following errors during any sequence/operation (e.g. power-on
sequence, paper feeding/loading sequence, ink sucking sequence).
Note : “–” : No change
Printer Status
Communication Error Ink Low Double Feed Paper Out
Indications
Power — — — —
Ink — On — —
Paper — — On On
Status monitor 3
message
Fault
Occurrence
Cause
This error occurs when the printer cannot
communicate with the PC correctly.
This error occurs when about 90 percent of
ink consumed.
Note :
Even if this error is indicated on the STM3,
you can continue printing until a "Replace Ink
Cartridge" error appears. However, the Head
Cleaning may not be performed during the ink
low status.
This error occurs when multiple sheets of
paper are fed simultaneously. The error
condition is detected when paper length
longer than its preset length is detected.
This error occurs when the PE sensor
failed to detect the top edge of a paper
during the paper feeding sequence.
Reference Page
Table 3-11, “Check point for
communication error according to each
phenomenon,” on page 61
---
Table 3-10, “Check point for double feed
error according to each phenomenon,” on
page 60
Table 3-8, “Check point for paper out
error according to each phenomenon,” on
page 57
To Next Page
Loading...
Need help?
Print Quality
Paper Handling
Weight and Dimensions
