PELLETS AND FEEDING
19
ENGLISH
obtained from an adjacent room, as long as the ow takes place
freely through permanent openings communicating with the
outside.
The adjacent room, with respect to the installation room, must not
be put in depression with respect to the external environment by
means of reverse draught caused by the presence of another used
appliance or intake device in such room. The permanent openings
in the adjacent room must comply with the above-described
requisites. The adjacent room cannot be set up as garage, storage
for combustion material or activity with danger of re.
INSULATION, FINISHINGS, 10.5.
COVERING AND SAFETY
RECOMMENDATIONS
The coverings, independently from the materials from which they
are made, must constitute a self-supporting construction with
respect to the heating block and not be in contact with it.
The cross members and nishings in wood or combustion
materials must be positioned outside the hearth radiation area or
adequately insulated.
If coverings in combustion material or sensitive to heat exist in the
space above the generator, an insulating and non combustible
protection diaphragm must be inserted.
Elements in combustible or inammable material like wooden
furniture, curtains, etc., directly exposed to the hearth radiation,
must be positioned at a safe distance. The appliance installation
must guarantee easy access for cleaning the appliance itself,
discharge gas pipe and ue.
NATIONAL, REGIONAL, 10.6.
PROVINCIAL AND TOWN COUNCIL
REGULATIONS
It is necessary to bear in mind all laws and national, regional,
provincial and town council Standards present in the country the
appliance has been installed.
PELLETS AND FEEDING11.
The pellets used must comply with the features
described by the Standard:
Ö-Norm M 7135
DIN plus 51731
UNI CEN/TS 14961
Extraame recommends the use of pellets with a
diameter of 6mm with its products.
WARNINGS!!!
THE USE OF EXPIRED PELLETS OR ANY OTHER
MATERIAL DAMAGES THE FUNCTIONS OF YOUR
STOVE AND CAN DETERMINE THE INVALIDITY OF THE
WARRANTY AND THE ANNEXED RESPONSIBILITY OF
THE MANUFACTURER.
To guarantee combustion without problems, the pellets must be
kept in a dry place. We recommend the use of pellets with diameter
of 6mm with our products. See the images for feeding pellets.
Open the tank lid and load the pellets using a scoop. In the
event of the inserts, only load when the machine is o and
cold, by extracting it from the compartment. In the event of
installation with feeding kit (optional) the machine must not
be extracted.
gure 19
To Next Page
Loading...
Need help?
General
