WARNINGS
5
ENGLISH
WARNINGS1.
Installation must be carried out by qualified staff and/or manufacturer technical assistance, who must provide the buyer with a
declaration of conformity for the system and will assume full responsibility for final installation and as a consequence the correct
functioning of the installed product. It is necessary to bear in mind all laws and national, regional, provincial and town council
Standards present in the country the appliance has been installed. The manufacturer cannot be held responsible for the failure
to comply with such precautions.
1.Electric connections: it is therefore recommended that after any intervention on the product, that authorised sta pay particular
attention to the electric connections, especially the stripped parts of the wires. These must not escape from the terminal board in any
situation, thus preventing possible contact with the live parts of the wire.
2. Type of use: this stove must be destined for the use for which it has been expressly realised.
3.Liability of the manufacturer: The manufacturer is exempt from any liability, contractual and extracontractual, for injury/damage
caused to persons/animals and objects, due to installation, adjustment and maintenance errors and improper use.
4.Check integrity of the product: After the packaging has been removed, check the integrity and completeness of the contents. If this
does not comply, contact the dealer where the appliance was purchased.
5.Electric connections: All electric components that make up the stove must be replaced with original spare parts exclusively by an
authorised after-sales centre, thus guaranteeing correct functioning.
6.Maintenance: The stove must be serviced at least once a year, programming it in advance with qualified staff and/or the manufacturer's
technical after-sales assistance. Nota bene: In case of thermo product or boiler, the product or system venting is not covered by the
warranty.
To Next Page
Loading...
Need help?
General
