FLIR FC-Series S User Manual

427-0073-12-12 Version 120 May 2015 2-3
2
Basic Operation and Configuration
viewed and the camera can be controlled (see section 2.3.4 “Using FSM” on page 2-7). FSM is
especially useful for confirming the functions of the GPIO connections.
2.3.2 Log in to the Camera Web Page
With a web browser, it is possible to log in to the camera using one of three User Names: user,
expert, and admin. By default, the passwords are: user, expert, and fliradmin, respectively. The
login passwords should be changed to prevent unauthorized log ins (refer to Basic Camera
Configuration, pg. 2-10).
Open a web browser and enter: http:\\192.168.250.116. The login screen with a picture of the camera
will appear. A pull-down list in the upper right allows the user to select a language option. Enter user
for the User Name and user for the Password, and click Log in.
The user login can be used to do the initial bench test of the camera. The expert login can be used to
make basic configuration changes such as setting the IP address. The admin login is used for more
advanced configuration changes, and is described in Advanced Configuration, pg. 3-1.
Note
Two web sessions can be active at once. An inactive session will be logged out after 20 minutes.
Figure 2-1: Camera Web Page Login Screen

FLIR FC-Series S Specifications

General

Brand	FLIR
Model	FC-Series S
Category	Thermal cameras
Language	English