Installation
5
427-0200-00-12 Revision 100
This document does not contain any export-controlled information.
2 Installation
This camera can be installed outdoors or indoors.
For outdoor installation, FLIR recommends:
·
Always using weatherproof equipment, such as boxes, receptacles, connectors, etc.
·
For electrical wiring, using the properly rated sheathed cables for conditions to which the cable will be
exposed (for example, moisture, heat, UV, physical requirements, etc.).
·
Planning ahead to determine where to install infrastructure weatherproof equipment. Whenever possible,
ground components to an outdoor ground.
·
Using best security practices to design and maintain secured camera access, communications
infrastructure, tamper-proof outdoor boxes, etc.
All electrical work must be performed in accordance with local regulatory requirements.
2.1 Supplied Components
The Saros DM-Series camera kit includes these items:
2.2 Site Preparation
There are several requirements that should be properly addressed prior to installation at the site.
The following specifications are requirements for proper installation and operation of the unit:
·
Ambient Environment Conditions: Avoid positioning the unit near heaters or heating system outputs.
Avoid exposure to direct sunlight. Use proper maintenance to ensure that the unit is free from dust, dirt,
smoke, particles, chemicals, smoke, water or water condensation, and exposure to EMI.
To Next Page
Loading...
Need help?
General
