EasyManuals Logo

Ford Escape 2013 User Manual

Ford Escape 2013
892 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #141 background image
FUEL QUALITY
Note: We recommend that you use only
high quality fuel without additives or other
engine treatments.
Do not use leaded gasoline or gasoline with
additives containing other metallic
compounds (e.g. manganese-based). They
could damage the emission system.
Choosing the Right Fuel
Note: Use of any fuel other than those
recommended may cause powertrain
damage, a loss of vehicle performance and
repairs may not be covered under warranty.
If your vehicle is not a flexible fuel vehicle,
then only use unleaded fuel or unleaded
fuel blended with a maximum of 15%
ethanol. Do not use fuel ethanol (E85),
diesel fuel, fuel methanol, leaded fuel or
any other fuel because it could damage or
impair the emission control system.
The use of leaded fuel is prohibited by law.
Your vehicle was not designed to use fuel
or fuel additives with metallic compounds,
including manganese-based additives.
Octane Recommendations
Regular unleaded gasoline with a pump
(R+M)/2 octane rating of 87 is
recommended. Some fuel stations offer
fuels posted as regular with an octane
rating below 87, particularly in high altitude
areas. Fuels with octane levels below 87
are not recommended.
Note: Premium fuel will provide improved
performance for vehicles with EcoBoost®
engines and is recommended for severe duty
use such as trailer tow.
Do not be concerned if your engine
sometimes knocks lightly. However, if it
knocks heavily while you are using fuel with
the recommended octane rating, see your
authorized dealer to prevent any engine
damage.
RUNNING OUT OF FUEL
Avoid running out of fuel because this
situation may have an adverse effect on
powertrain components.
If you have run out of fuel:
You may need to cycle the ignition from
off to on several times after refueling
to allow the fuel system to pump the
fuel from the tank to the engine. On
restarting, cranking time will take a few
seconds longer than normal. With
keyless ignition, just start the engine.
Crank time will be longer than usual.
Normally, adding 1 gallon (3.8 liters) of
fuel is enough to restart the engine. If
the vehicle is out of fuel and on a steep
grade, more than 1 gallon (3.8 liters)
may be required.
The service engine soon indicator may
come on. For more information on the
service engine soon indicator, See
Warning Lamps and Indicators
(page 80).
Refilling With a Portable Fuel
Container
WARNINGS
Do not insert the nozzle of portable
fuel containers or aftermarket
funnels into the capless fuel system.
This could damage the fuel system and its
seal, and may cause fuel to run onto the
ground instead of filling the tank, which
could result in serious personal injury.
141
Fuel and Refueling

Table of Contents

Other manuals for Ford Escape 2013

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ford Escape 2013 and is the answer not in the manual?

Ford Escape 2013 Specifications

Curb Weight IconCurb Weight
curb weight 1.6L FWD3502 lbs
curb weight 1.6L 4WD3645 lbs
curb weight 2.0L FWD3592 lbs
curb weight 2.0L 4WD3732 lbs
curb weight 2.5L FWD3515 lbs
Seating and Interior IconSeating and Interior
seating capacity5
head room front39.9 inches
head room rear39.0 inches
shoulder room front56.0 inches
shoulder room rear55.3 inches
hip room front54.8 inches
hip room rear52.4 inches
leg room front43.1 inches
leg room rear36.8 inches
Passenger and Cargo Volume IconPassenger and Cargo Volume
passenger volume98.1 cu. ft.
cargo volume behind 1st row67.8 cu. ft.
cargo volume behind 2nd row34.3 cu. ft.
total interior volume132.4 cu. ft.
Fuel IconFuel
fuel tank capacity15.0 gallons
fuel requirement87 octane
fuel economy 2.5L FWD22/31 mpg (city/hwy)
fuel economy 1.6L FWD23/33 mpg (city/hwy)
fuel economy 1.6L 4WD22/30 mpg (city/hwy)
fuel economy 2.0L FWD22/30 mpg (city/hwy)
fuel economy 2.0L 4WD21/28 mpg (city/hwy)
Engine Specifications IconEngine Specifications
engine type 1.6LEcoBoost I-4
engine type 2.0LEcoBoost I-4
engine type 2.5Li-VCT I-4
displacement 1.6L97.6 cu. in.
displacement 2.0L122 cu. in.
displacement 2.5L152 cu. in.
horsepower 1.6L178 @ 5700 rpm
horsepower 2.0L240 @ 5500 rpm
horsepower 2.5L168 @ 6000 rpm
torque 1.6L184 lb.-ft. @ 2500 rpm
torque 2.0L270 lb.-ft. @ 3000 rpm
torque 2.5L170 lb.-ft. @ 4500 rpm
compression ratio 1.6L10.0:1
compression ratio 2.0L9.3:1
compression ratio 2.5L9.7:1
bore and stroke 1.6L3.11 x 3.20 inches
bore and stroke 2.0L3.44 x 3.27 inches
bore and stroke 2.5L3.50 x 3.94 inches
fuel system 1.6LDirect Injection
fuel system 2.0LDirect Injection
fuel system 2.5LSequential Multiport Injection
Weight and Dimensions IconWeight and Dimensions
wheelbase105.9 inches
length178.1 inches
height66.3 inches
width with mirrors81.8 inches
width without mirrors72.4 inches
track front61.5 inches
track rear61.6 inches
ground clearance7.9 inches

Related product manuals