EasyManuals Logo

Ford Escape 2013 User Manual

Ford Escape 2013
892 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #155 background imageLoading...
Page #155 background image
Note: Excessive tire slippage can cause
transmission damage.
4WD vehicles have advantages over 2WD
vehicles in snow and ice but can skid like
any other vehicle. Should you start to slide
while driving on snowy or icy roads, turn
the steering wheel in the direction of the
slide until you regain control.
Avoid sudden applications of power and
quick changes of direction on snow and
ice. Apply the accelerator slowly and
steadily when starting from a full stop.
Avoid sudden braking as well. Although an
4WD vehicle may accelerate better than
a two-wheel drive vehicle in snow and ice,
it won't stop any faster, because as in other
vehicles, braking occurs at all four wheels.
Do not become overconfident as to road
conditions.
Make sure you allow sufficient distance
between you and other vehicles for
stopping. Drive slower than usual and
consider using one of the lower gears. In
emergency stopping situations, apply the
brake steadily. Since your vehicle is
equipped with a four wheel anti-lock brake
system (ABS), do not pump the brakes.
Refer to the Brakes section of this chapter
for additional information on the operation
of the anti-lock brake system.
Maintenance and modifications
The suspension and steering systems on
your vehicle have been designed and
tested to provide predictable performance
whether loaded or empty and durable load
carrying capability. For this reason, Ford
Motor Company strongly recommends that
you do not make modifications such as
adding or removing parts (such as lift kits
or stabilizer bars) or by using replacement
parts not equivalent to the original factory
equipment.
Any modifications to a vehicle that raise
the center of gravity can make it more likely
the vehicle will rollover as a result of a loss
of control. Ford Motor Company
recommends that caution be used with
any vehicle equipped with a high load or
device (such as ladder or luggage racks).
Failure to maintain your vehicle properly
may void the warranty, increase your repair
cost, reduce vehicle performance and
operational capabilities and adversely
affect driver and passenger safety.
Frequent inspection of vehicle chassis
components is recommended if the vehicle
is subjected to off-highway usage.
155
Four-Wheel Drive (If Equipped)

Table of Contents

Other manuals for Ford Escape 2013

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ford Escape 2013 and is the answer not in the manual?

Ford Escape 2013 Specifications

Curb Weight IconCurb Weight
curb weight 1.6L FWD3502 lbs
curb weight 1.6L 4WD3645 lbs
curb weight 2.0L FWD3592 lbs
curb weight 2.0L 4WD3732 lbs
curb weight 2.5L FWD3515 lbs
Seating and Interior IconSeating and Interior
seating capacity5
head room front39.9 inches
head room rear39.0 inches
shoulder room front56.0 inches
shoulder room rear55.3 inches
hip room front54.8 inches
hip room rear52.4 inches
leg room front43.1 inches
leg room rear36.8 inches
Passenger and Cargo Volume IconPassenger and Cargo Volume
passenger volume98.1 cu. ft.
cargo volume behind 1st row67.8 cu. ft.
cargo volume behind 2nd row34.3 cu. ft.
total interior volume132.4 cu. ft.
Fuel IconFuel
fuel tank capacity15.0 gallons
fuel requirement87 octane
fuel economy 2.5L FWD22/31 mpg (city/hwy)
fuel economy 1.6L FWD23/33 mpg (city/hwy)
fuel economy 1.6L 4WD22/30 mpg (city/hwy)
fuel economy 2.0L FWD22/30 mpg (city/hwy)
fuel economy 2.0L 4WD21/28 mpg (city/hwy)
Engine Specifications IconEngine Specifications
engine type 1.6LEcoBoost I-4
engine type 2.0LEcoBoost I-4
engine type 2.5Li-VCT I-4
displacement 1.6L97.6 cu. in.
displacement 2.0L122 cu. in.
displacement 2.5L152 cu. in.
horsepower 1.6L178 @ 5700 rpm
horsepower 2.0L240 @ 5500 rpm
horsepower 2.5L168 @ 6000 rpm
torque 1.6L184 lb.-ft. @ 2500 rpm
torque 2.0L270 lb.-ft. @ 3000 rpm
torque 2.5L170 lb.-ft. @ 4500 rpm
compression ratio 1.6L10.0:1
compression ratio 2.0L9.3:1
compression ratio 2.5L9.7:1
bore and stroke 1.6L3.11 x 3.20 inches
bore and stroke 2.0L3.44 x 3.27 inches
bore and stroke 2.5L3.50 x 3.94 inches
fuel system 1.6LDirect Injection
fuel system 2.0LDirect Injection
fuel system 2.5LSequential Multiport Injection
Weight and Dimensions IconWeight and Dimensions
wheelbase105.9 inches
length178.1 inches
height66.3 inches
width with mirrors81.8 inches
width without mirrors72.4 inches
track front61.5 inches
track rear61.6 inches
ground clearance7.9 inches

Related product manuals