Operation
If the selected input signal does no t deliver an image, the monitor
shall change this automatically.
In the following cases an automatic change of the input signal is disabled:
• When the "Daisy-Chain" function is activated.
• If the input signal for the "USB-C" monitor connection is selected and
the Power Button settings is set to "Computer".
Press the button
To ca l l up t he INP UT settings window if the monitor
is not displaying an image and is in power-saving mode.
If on the USB-C upstream p
ort a sheer USB data connection is detected, an
enlarged setting windo
w will be displayed.
► Press the / buttons to select the desired monitor port.
► Press the
/ buttons to change the assignment of the USB upstream to the relevant
video signal.
The built-in KVM will b e switched based on the a ssignments set.
For furth
er information on the KVM function, please refer to chapter
"
KVM feat
ure", Page 55.
38 Fujitsu
To Next Page
Loading...
Need help?
General