Additional information
USB Power Delivery (USB-PD)
USB-PD is a function defined by the USB Implementers Forum, Inc., in accordance with the current
specification of USB-PD Version 2.0. It provides a way to deliver current via the USB-C cable, and
charge powe r of up to 95 W, a convenient way fo r you to recharge your Notebook or Tablet.
For this, the monitor must be in operating mode, readiness mode or All-in-One
mode. No USB-PD is possible when disconnected.
To ensure security and compatibility, only the supplied USB-C cable or an
equivalent certified USB-C cable must be used.
The USB-PD function is protected by an electrical overcurrent device. If current exceeds
4.75 A, USB-PD is switched off as a precautionary measure. In this case, disconnect
the device, check it for defects and reconnect it to be able to use USB-PD again.
This monitor was test
ed using systems developed by FUJITSU, requiring power
delivery of max. 95 W
via USB-PD. For other systems that only accept their own
brand of USB-PD cha
rging device due to specific power delivery directives, the
USB-PD support for
this monitor may be limited. Please note that any restriction
of this kind on the s
ystem will be due to the b ra nd involved.
On the manufactur
er’s website of your Notebook or Tablet, check that the latest firmware
is installed for y
our USB-PD controller. By installing more recent USB-PD co ntroller
firmware, you can
avoid compatibility problems with charging operations.
Only one USB port on this monitor s upp orts USB Power Delivery with up to 95 W. The other USB
ports deliver conventional USB charge current. You can identify proper connection by this symbol:
Symbol Port Power supply
USB-C upto95W(USB-
PD)
USB-C
up to 15 W
USB-A
up to 4.5 W
54 Fujitsu
To Next Page
Loading...
Need help?
General