Fujitsu ScanSnap S300 Getting Started Guide

ScanSnap S300 Getting Started 20
■ Turning the ScanSnap ON
1. Open the Paper chute of the ScanSnap.
2. The ScanSnap is turned ON.
⇒ The Power indicator starts blinking, and becomes solid. Then, the ScanSnap is
recognized as new hardware by your computer.
ATTENTION
• Be sure to use the supplied USB bus power cable.
• Be sure to use the supplied USB cable.
The operation with any commercially available USB cable is not
guaranteed.
• If only the USB cable is used, the ScanSnap does not operate. Be
sure to use two types of cables, the USB bus power and USB, to
connect the ScanSnap to a personal computer.
Or, use a powered hub equipped with an AC adapter, and connect
both cables to the same hub.
• When connecting to a USB hub, be sure to use the first stage USB
hub that is closest to the computer. If you use the second or later hub
stages, the scanner may not operate properly.
• When connecting with a USB 2.0 cable, make sure that the USB port
to connect to and hub must be USB 2.0-compliant. Note that if
connected with a USB 1.1 cable, the scanning speed may become
slow. When a USB 2.0-compliant port is available, it is recommended
that the USB 2.0-compliant port be used.
ATTENTION
The scanner is turned on/off automatically, when you open/close the
Paper chute.
It is also turned on/off in conjunction with the connected computer’s
power on/off status.
HINT
Depending on the performance of the computer and the load on it, it may
take time before the power LED gets illuminated. For example, it may
take time if there are many programs running on the computer.
In such case, wait until the power LED is steadily on.
Paper chute

Fujitsu ScanSnap S300 Specifications

General

Film scanning	No
Color scanning	Yes
Input color depth	- bit
Maximum scan size	216 x 360 mm
Scanner type	Sheet-fed scanner
Sensor type	CIS
Minimum scan area (ADF)	50.8 x 50.8 mm
ISO A-series sizes (A0...A9)	A4, A5, A6
ISO B-series sizes (B0...B9)	B5, B6
Maximum ISO A-series paper size	A4
Auto document feeder (ADF) input capacity	10 sheets
Bundled software	ScanSnap Manager V4.2, ScanSnap Organizer V3.2, CardMinder V3.2
Scan media weight	64 - 104.7 g/m²
Dimensions (WxDxH)	284 x 95 x 77 mm
Power requirements	AC 100V to 240V, 50 / 60 Hz
Dimensions (W x D x H) (imperial)	11.18 x 3.74 x 3.03 \
Maximum scan area (ADF) (imperial)	8.5 x 14.17 \
Minimum scan area (Auto Document Feeder)	2 x 2 \
Minimum RAM	512 MB
Minimum storage drive space	920 MB
Compatible operating systems	Windows 2000 Professional, Windows XP, Windows Vista
Power supply type	AC/USB
Power consumption (standby)	5 W
Power consumption (typical)	9 W
Sustainability certificates	ENERGY STAR
Operating temperature (T-T)	5 - 35 °C
Operating relative humidity (H-H)	20 - 80 %
Certification	RoHS

Weight and Dimensions

Weight	1400 g