3. TARGET TRACKING (TT)
3-24
3.16.4 How to sleep/deactivate an acquisition zone
1. Select the appropriate [AZ] box.
2. Sleep, or deactivate, the acquisition zone, as explained below:
Sleeping the acquisition zone
Left-click the box several times until the indication shows "SLEEP".
Deactivating the acquisition zone
Left-click the box until the AZ box becomes blank.
Note: When both zones ([1:] and [2:]) are active, [2:] must be deactivated before
[1:] can be deactivated.
If [1:] and [2:] are active when you try to deactivate [1:], the system releases an
audible alert and shows the message "DELETE AZ2 FIRST".
3.16.5 How to acknowledge the acquisition zone alert
Press the ALARM ACK key on the control unit, or select the [ALERT] box with the
trackball then left-click to acknowledge the alarm and silence the buzzer.
3.16.6 How to select the target type to acquire (B/W-types only)
You can set the radar to acquire on TT targets, or both AIS and TT targets. To select
the target type to acquire, do the following:
1. Open the menu.
2. Select [5 TT•AIS].
3. Select [2 ACQUISITION ZONE].
4. Select [3 TARGET TYPE TO ACQUIRE].
5. Select [TT AND AIS] or [TT ONLY] as appropriate.
6. Close the menu.
To Next Page
Need help?
General
